You think ? :)

Yes, 1.7vcore.
Temps are -99° in bios, don't know what the real one is :p
Must check mounting, redone it a few times, and always the overclock goes higher.
A capasitor must be in the way of perfect mounting.

I was expecting a closer shot of your mounting (and perhaps a shot of the two units, I see only a hose above your cpu :p )

your wish will be granted :)

Simplest mounting ever :).

Just tighten the thing real hard :D.

Screws are at maximum strengh, must be something else.

Be careful when you tighten the screws, you're mobo may bend, which can result in lower clocks (been there ...).

Just mount the evap on the cpu and PRESS the mounting as hard as you can onto the cpu. Then tighten the screws. This way, you'll have perfect contact and the board won't bend. You'll notice that the screws can be tightened a little bit more, but leave it the way it is.

By the way, your results made us jump to place 15 again :D

nice setup:) what temps do you get on the GPU?

LOL why using multi 8,
use multi 10 :)

actually I DID massman ;)

thats a strange mount for a vga :D
gamer make sure ur O ring dont come of , my stainlessteel on jumped of en killed the card :( .
btw make a good hold down :p its easy as hell :)
Attachment 975
the card benched for a hole week and the it just died :(

I don't think hardware in your hands "just dies" ;)

I know ... didn't see your profile in the top5 members, so I didn't know you joined us :D

ok, tried everything, this CPU will not go any higher :(

LOL then you have the suckiest phase ever :D

hit me on msn m8 :)

we have same boards so...

Did the VDroopmod, gained about 150mhz :)
This thing just needed more voltage.

you should specify GPU or CPU:p was afraid you gained 150Mhz on 7300 GT GPU OC:p

Now that would be cool.
This will be one of my last benches, see you next year all :p

Contest runs until end of August ;) currently you are not in the lead of Aircooled category ;)

I only need a good aircooler, that's it to beat Troman.
Noticed I could fit the Hyper6+ on it, that should improve my score :)

do remember that at the end of the summer, a lot of peeps will be benching their 7300GT, most likely outscoring your first entrees here;)

Nono, that's not the spirit :D

excuse me?:-p

he said that where ever Gamer got his phase change unit, that it sucks! sjeesh we need to repeat everything here don't we?

;)

haha Tnx for repeating it :D

Hehe, your fault Jort :p

I know, was not tuned for the heatload of today neather.

Srry ;-)

how do u meen overcharged ?
if so its easy to tune it :)

Nah, all I miss is voltage, that's all.
I gained 200 mhz by doing the vdroopmod, so.

So why no vcore mod?

skill :p

vcore mod not needed.

sweetspot should be around 1.7V for that chip.

with skill lol .
u wish u had a vcore mod when u have LN² ;)

he doesn't have LN2....

Lol what is the sense of this post?

Just made us look less bad on HWbot, gained a few boints.

What is it with the team ?
Everybody is on a holiday ? :p

summers tends to do that:p

I have some goodies at home which needs subzero cooling ... :)

En plus, Lanscape is pretty soon |D

lets say we have the friday LN² + single card and E6850 benches this will be done @ saterday morning or noon some sleep and then its benching SLI 8800 ultra's with a QX6850 or QX6800 .
alles mag gevmod worden en er zijn containers zat ;) .
btw massie al contact op genomen met air liquide ?

hehe nice benches gamer E6850 is doing its job ;) , still u did not beat my X800 .

Atm zit ik in Frankrijk, dus air liquide zal voor maandag zijn, tenzij gy ff informeert :)

Speed it up Massman, we are almost on second page :p
Gained a spot again, others are not on a holiday it seems :)
Geoffrey is my next victim....

Almost as in +550 points? :D