| ||Thread Tools|
|24th September 2003, 15:34||#1|
I got the pelt setup running like this : pump -> dual bix rad -> cpu -> single bix rad -> mcw50-t and gf4ti4600 -> pump.
But the gf4 is only at 22°c! (got the temps from the backside of the gpu)
I've ran the pelt without the gf4 and it was doing -0°c in a few sec.
First i got +-30°c but then i saw the mcw50-t wasn't making good contact. Now i've remounted it and its about 22°c..
My cpu @2425mhz is running at 35°c.
I tought a pelt would run @ about +-5°c ..
What am i doing wrong?
|24th September 2003, 15:44||#3|
I got a a little temp probe and the sensor is at the back of the gpu..
Sure it's normal? Couse my cpu is only doing 10°c more without a pelt @ 2425 and 1.8vcore.
All fans are on low speed and there's no fan on the single rad..
Still have to get one! So maybe that's the problem?
|Thread||Thread Starter||Forum||Replies||Last Post|
|whats the source of the problem?||Zemfik||Hardware/Software Problems, Bugs||1||18th March 2008 19:23|
|P4 805 Oc same as the test but... problem||Opcod||Hardware Overclocking and Case Modding||7||8th June 2006 16:56|
|Acer Aspire 1705SMi problem.||Blackbyte||Hardware/Software Problems, Bugs||3||14th March 2006 17:09|
|HOWTO: Troubleshoot Any Networking Problem||jmke||FAQ / INFO / HOW-TO||0||15th February 2006 14:33|
|Problem with new mobo Abit KV8 pro||dorfke||Hardware/Software Problems, Bugs||6||4th October 2004 23:23|
|HD error problem||Darkstar||Hardware/Software Problems, Bugs||2||21st February 2004 15:21|
|problem with msn messenger||[Bonbon]||General Madness - System Building Advice||3||5th February 2004 10:15|
|Help needed: R9800pro problem||FoRCe||Hardware/Software Problems, Bugs||22||13th January 2004 16:02|
|the 333mhz problem||kipni||Hardware Overclocking and Case Modding||0||22nd May 2003 15:47|
|boot problem with abit th7-II||The Senile Doctor||Hardware/Software Problems, Bugs||22||11th June 2002 00:15|