BH5 normaly does not run on cas 3.
cas 2,5 shouldn't give you much higher mhz than cas 2

That's right !
CAS 2.5 -> MAYBE 1MHz in more than CAS2
CAS 3 -> No boot !

I have "old" CH-5 (not UTT that is) that clocks @ 245 MHz 2-2-2-5 at 3,2V. Not bad I think. But BH-5 should do better... So I'm interested.
But how about warranty??

it goes through him apparantly

Warranty -> You send me and I send at factory (Maybe I can make a echange).

Gone

Only one little error for a night @ 265 MHz @ 3.6V :D

ow :(

one error would mean PC stable for ~11 hours then crash.. :(

Nope, the error occured in pass 10. That was after a bit more then 3 hours. But the screenshot shows 11 hours of testing, that means that there were no errors during 8 hours after that error.
But I doubt the PC would crash.

I don't know if I'm going to buy this memory. I have my doubts because I'm afraid to use the 5V-jumper on my DFI nF4. I've seen many owners of the DFI nF4 that have dead memory modules now. The bord is somehow killing the memory when using Vmem above 3,3V :grum: :(

my single stick of bh5 does 260@3.18V but my other won't :p