trut :p

not ink mate use the volt mod I showed ya ( these cards are all shader limited ) sometimes it's better to run unlink and keep the shader at max 1697 (voltmodded)


+1 TRUT (9600GT lol)

:p

I might hook up the E8600 to the Mach2 to have at least 1 score, but it won't be spectacularly high

I'm going to do the mod you linked before:
So I need the conductive ink, no?

What cooling?

On Phase this was the max for this CPU, 5.7Ghz was BSOD etc

Geoffrey soldered me 285 ( the wizard )

Ik volg even niet :p
Je geeft me een link om een 260/280/285 te modden, met conductive ink om Vmem en Vgpu te verhogen. Da's hetzelfde als die bruggen dicht te solderen, maar ik vind geleidende inkt makkelijker werken...
Maar wat bedoel je dan met "not ink mate use the volt mod I showed ya"?

Er zijn er een paar die inkt gebruikt hebben en hopen probs hadden erna. Ik heb dadelijk het zekere voort onzekere genomen en Geoffrey gevraagd om te kaart te modden

Was able to do a few quick 1M runs under Mach2 this evening, here's my first run:

8.25 - E8600 @ 5.5G - http://hwbot.org/result.do?resultId=856718

I've put my E8600 under my Vapochill LS. It can do 5350MHz even SuperPi 32M stable, but can't do 5450MHz SuperPi 1M :(
I tried changing the RAM-timings from 4-4-4-12 to 5-5-5-15, setting performance level to Standard in stead of Turbo, higher Vcore, higher Vmem, higher Vmch, but I still can't get over that 545MHz FSB.

My settings are:


Any ideas?

is that UD3P ? Lower MCH voltage ( very heat sensitive) and mess with the reference voltage and check via memtest ( test 5 and 7 ) before entering windows

Some CPU's just need masses of FSB term voltage, but my bet is on the Nb , more isn't always better...