We go at this from the bottom up. First of all I would like to show you the "power" of this heatsink, a magnetic-based motor that serves as a pump to let the water go round and round:



The pump fits in here:



I made sure that I screwed everything down tight, don't want any leaks:



This is how the Aluminium sink looks like sideways:




The bottom's fairly flat, but far from perfect:



The radiator is made out of copper and the connection between the sink & radiator is "insulated" by a rubber/plastic string:



This insulation method is far from perfect and I had to verify everything over and over to see that everything fitted as it should, because the rubber string jumped out of it's groove quite often:



Time to put some pieces of the puzzle together:



Okay, with the radiator installed it looks like this:



First test-run is up next...