- Back to homepage
- Related articles
  Related articles

Koolance PC2-C >> Antec Plusview 1000

Modding/Case Mods by Lapino @ 2003-02-22

A small article on how I installed the watercooling unit from the Koolance PC2-C case into my Antec Plusview 1000! I found the aircooling of my P4 2.8Ghz way too loud so I set out to get this baby watercooled, and while we?re at it why not chill my Radeon also?

Koolance >> Antec

I started this mod yesterday, I planned to install the water-cooling from my Koolance PC2-C into my Antec PlusView 1000.

Madshrimps (c)

So I got going, removed all the parts from the Koolance:

Madshrimps (c)

I encountered my first problem, the top of the ANTEC case is riveted and it took me 30min with my drill to remove the top:

Madshrimps (c)

I then measured the dimensions of the radiator and fans, I marked it & used my Dremel to get this result:

Madshrimps (c)

I then started to look for the best spot in the Antec case where I could put the reservoir & water pump, after making a hole in the bottom (to be able to refill the reservoir) I had it installed down there.

The next challenge was finding a suitable location for the "control" unit, after some research I found out that using some motherboard studs I could attach it safely without risk of a short-circuit.

Madshrimps (c)

All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.