Engraving tutorial If you are engraving plexi to use in a case mod project, it is common practice to use LEDs to add some light to your design, bringing it to life. A useful trick is to engrave to different depths to alter the brightest of the light: if you engrave three lines at different depths, the deepest will shine the brightest. Used appropriately, this technique will produce a feeling of depth and produce highlights to an engraving. Think of your Dremel like you would a car: while it may be capable of high speeds, the higher the speed the more difficult it is to handle. Maximum control is had at lower speeds: the bit is less likely to skip acros the surface, and you will avoid melting the tyres acrylic/plexi you're working on. http://www.bit-tech.net/modding/2005..._modder/1.html |
For the artistically inclined only :( Far too complicated for me. |
same here. You can use printouts or have an artist do the scetching for you. I'm pretty good with a dremel, but I just can't draw. |
All times are GMT +1. The time now is 12:42. |
Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO