Speedfan configuration Either I am overlooking an option.. or this does not work. using [g]Speedfan[/g] I want to automatically speed up/slow down fan linked to CPU temp. desired temp 50°C alert temp 70°C set to control the CPU fan. CPU fan has min.0 and max 100 set. this is what I get when I put CPU under load: |
so the FAN speed is set to 100% each time CPU is >50. is there a way to make the fan increase gradually? Like 1-2% steps at a time; what if 60% CPU fan speed is enough to keep CPU at 50°C... can this program do this? or are the steps for the FAN 0, 50, 100% CPU temp: |
Never use it; but, I think. 1) check auto fan speed 2) set 50% (if half is what you want) or any % The fan speed wil increase from this point on when temp gets higher. Big Assumption on my part. |
No, I don't know what I was talking about. Doen't work. |
configure>options Delta value for fan speeds. Settings this at a lower rate will make speedfan take smaller steps to increase fanspeed. Is 50% realy 50%, or is it more like 95%, because here 15% is almost 90% fan speed. |
depends on the board actually; on DFI 50 = 50 on older P4 board 50 = less then 50;) |
All times are GMT +1. The time now is 08:51. |
Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO