I'm terribly sorry, but only in inox.
please do remember that everthing is done after the houres, I my dad isn't exactly looking for trouble. And I'm not sure if it could be done. 'The laserhead' is 'afgesteld' op inox and unless you're willing to pay more that half a million for a new one....

hmmz...let's think
inox is much heavier then alu
so, the laser needs more watt's to cut
alu is lighter=>less watts used to laser. result?
-what lies under the inox plate? that thing might get damaged
-your expensive alu sidepanel gets f***ed up: as much more watts will be applied (and alu conducts heat better then inox!), i think the area around were you lasercut will be blurry. in the worst case, it will be blurry and little bent to the inside

might be wrong, but that's what i think

When can they be done?
what's your asking price?

don't think so cause you can have it done at cube-computers but the price is too expensive (50 € / cut)

perhap's they've got a other type of cutter?
will be a less expensive one i think, they're just a shop!

they don't do it themselves, think they got some kind of factory that does it for them.

I need to know how many you want, and exact measurements.
And it can take quite some time.

size= bankcontact card
number= at least 20

[M] lasercutted out in the perfect middle

8.5 * 5.5 cm?
welk lettertype is da?

Verdana