just drill some holes into the fridge and put your motheboard into the fridge :)
3-5° will do fine i guess

well ...
i´m not :mad: enough to do what YOU want (i know its possible but dunno how)

wait for replies from other peeps on the board

so you have 2 have an evaporator.
i don't know where you can find one.don't think nor chip-con nor vapo will supply you one.
i think your best shot is to make from your fridge a chiller

indeed, waterchiller will work

PC in fridge will get ya too many humididty probs u know

i think there will be a large form of condense on the outside of the waterblock if you do that

am i right ? :p

i'm building somethink like that with the peeps@ colorcase :)
we're thinking about to copy the micro-freezer now. no real clue how to do that ;p

waterbock= useless.
most of them can't handle the pressure nor the extreme cold temps.
and it's to big (way to much condensation)

that piece of art deserves 1st page publicity :super:

update :

pic met een beetje theorie

dit komt er

maar DIMMU is lijk weinig online

In a Phase Change system the Block is yet again totally different in what it does. In a Phase Change setup, its called the Evaporator simply because that's what it does. This is the epicenter of the phase change. The Liquid that enters the block/evaporator is very compressed, and has a very low boiling point. When it enters the evaporator, it boils off, and takes a ton of heat with it in gas form. This can yield many degree below 0 temps with ease. The Evaporator has to be able to take the intense pressure and temp swings that happen on these systems, they also must be made very efficient in order to get the heat from the core to the evaporation chamber as fast as possible. A system like this does not benefit as MUCH as water cooling systems with the heat spreader, but its still needed for a few reasons. The first one is temp shock. You don't want freon spraying on your core at -50C onto a core that is cooking at 80C, that would shatter the core instantly. The heat spreader acts as a mediator to slow down the instant temp shocks, as well as mediate the movement of heat away from the core.


Zeggen ze nu hier dat het niet al te best is als je dat doet?
maar een promethia maakt toch ook -30 op de core?
waarom barst die dan niet?

kijk wa rond op www.phase-change.com
hebben zelfs how-tos
anders vragen stellen op forum

heb hen ooit gevraagd ofdat ze intresse hadden in samenwerking met [M] .. spijtig genoeg niet door gegaan :-/

zeer spijtig aangezien er in belgie er al een beperkt aantal "dedicated" overclockers/modders zijn, en deze dan nog over verschillende sites/forums hun bezigheden hebben

:(

ps: ik zie geen howto's op P-C.com die verband hebben met deze topic :grum: