when i set 1.6 vcore in bios, in windows my voltage is higher (+-1.675, while stressing vcore drops a bit. So your vcore is 1.65 is bios?

And i'm not planning to do a droopmod, it's a waste of time for a bit more performance :D

It's all chip dependent;

The following is what I've experienced with Northwood.

1) One 2.4C no matter how high the vcore, it wouldn't go over 3.06 ghz.
2) Second 2.4C 3.24 Ghz 270 FSB @1.70 Volt; 275FSB 1.725 V.
3) 2.6C no matter how high the vcore; 3.32 or 255 FSB.
4) 2.8C no matter how high the vcore 250FSB

None is restricted by memory; it's the nature of the particular processor. The 2A could go 3.34 Ghz at 1.750V.

For p4, you don't want over 1.80 Volt; non temp related, the proc will have a sudden death from over voltage rather than death from heat.

Some lucky guy will get 3.6 Ghz from 2.4C with 1.70 Volt; some wouldn't get over 3 Ghz.

When is set my FSB to 260 I have to push the vcore to 1.7 in bios, otherwise i receive errors in prime. In windows while prime95 is running it gave me a vcore of +-1.6 and it' s stable.

Is the vcore psu dependant?
BTW 3.3v and 5V are veryy stable, only 12V goes to +-11.75

Others may have different opinons; here is mine.

Accurate voltage power supply delivers clean power to a mother board that has below specs power delivery = low voltage at the end.

Most boards are under volt. We would only hope the voltage sensor reading is accurate adding another variable.

yep, my opinion too, get a better PSU, had the same problem with my mobile. The chieftec is a nice standard PSU but not when you go to decent oc. and this is a nice oc already.

changed my chieftec 360 to enermax 465 and mobile went stable from 2500 to 26++


duploxxx

It 's strange because my 3.3v, 12v,5v are very stable. only my vcore drops(0.1) while stressing and that's the reason why i can t oc further.
I''ll try to bench without those fans (vantec tornado needs a lot of power).

after reading this i know that 's not psu related but it's chip dependant.

jmke did you do any mods on your p4c800???

nope, it's stock


overclock is Chip and PSU dependant, eliminating the PSU by getting a HQ one will make the job easier ;)

Which PSU do you suggest?

I've read good things about antec and tagan PSU's