great :)

Blind ripper's prom is evacuating:)

i'll try to make yours tomorrow.

If everything goes fine 2 Prom's will be shipped wednesday!

;)

drilled The holes for suction and capillair



Purging with propane



clean copper on the inside



Almost ready to power it up



I brazed a piece of 1" copper between the suction to act like the accumulator on the mach2

results tomorrow;)

flamingboy! :cool:

:excellent

Something strange is happening, when i start the Prom it runs smooth too -56 Evap temp bu then it goes to -66 and the pressure is going down.
this is because something is jamming the cappilairy tube.

going to replace the filter and a 3H vacuming of the unit.

replaced the filter, did a 4H vacuum and Gamer's mach 1 is now running

bios=> -24° on 1.79V stock speeds

i'll see what i can get out of this beast;)

edit: smartguardian saids 218-219° so minus 255 it was i tought.
=> ~ -35° idle

:super:

lets crank those mhz UP:grin:


edit2: damn coldbug :grum: , running some PI to raise the clocks then :D

Btw gamer the display saids -82 :D

i set the buzz at -90 8-)

:D

its a very bad Superpi time but i don't care its just testing;)

wow, killer temps :)

did you measure the real idle temp ?