You think ? :)

Yes, 1.7vcore.
Temps are -99° in bios, don't know what the real one is :p
Must check mounting, redone it a few times, and always the overclock goes higher.
A capasitor must be in the way of perfect mounting.

I was expecting a closer shot of your mounting (and perhaps a shot of the two units, I see only a hose above your cpu :p )

your wish will be granted :)

Simplest mounting ever :).

Just tighten the thing real hard :D.

Screws are at maximum strengh, must be something else.

Be careful when you tighten the screws, you're mobo may bend, which can result in lower clocks (been there ...).

Just mount the evap on the cpu and PRESS the mounting as hard as you can onto the cpu. Then tighten the screws. This way, you'll have perfect contact and the board won't bend. You'll notice that the screws can be tightened a little bit more, but leave it the way it is.

By the way, your results made us jump to place 15 again :D

nice setup:) what temps do you get on the GPU?

LOL why using multi 8,
use multi 10 :)

actually I DID massman ;)

thats a strange mount for a vga :D
gamer make sure ur O ring dont come of , my stainlessteel on jumped of en killed the card :( .
btw make a good hold down :p its easy as hell :)
Attachment 975
the card benched for a hole week and the it just died :(

I don't think hardware in your hands "just dies" ;)