Suggestion (even though I took the idea of someone else): couldn't you create some kind of channels in the IHS (like the Nexos HP-Pro...) and then do a direct-on-IHS watercooling? I hope you understood me :D |
I think you will get better results removing the IHS all together in that case, since creating channels in the IHS is pretty extreme too ;) |
this 2.0 "A" is running stable at 2.7ghz using 1.65v vcore and aircooling :) |
My 2A runs at 3Ghz at same voltage. They are very good OCer. Goes higher with 800 mhz board. =-) |
hmmmm.. should be doing something wrong then.. let me see if I can get it to run @ higher speed :) edit: 3ghz = okay , running F@H session no problem so far :) |
You're welcome. :klap: |
What coler was used? Was the cooler lapped aswell? |
cooling: read 4th post :) cooler is pretty flat already |
I got myself a lappings kit form tweakstore. 1 x 400grid (23 x 28cm) 1 x 600grid (23 x 28cm) 1 x 800grid (23 x 28cm) 1 x 1000grid (23 x 28cm) 1 x 1200grid (23 x 28cm) 1 x 1500grid (23 x 28cm) 2 x 2000grid (14 x 28cm) 2 x 2500grid (14 x 28cm) With this i think u can get 3° lower then stock. I know its hard to find anything higher then 600 in DIY shops. U could try "carroserie werken" as they need very fine paper. |
Even for paintjobs on cars and such, they rarely go higher then a 1200-1400 grain. Perhaps special-paint painters ;) will go the extra mile by using 2xxx grain sandpaper. |
All times are GMT +1. The time now is 10:40. |
Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO