T-Balancer & Attenuator – Configuration Possibilities
The T-Balancer output signal uses a square wave or PWM signal instead of the typical Analog type signal that a PSU or POT style fan controller would use. Personally I’ve found that most every fan (even Orange Yate Loons) produce more noise when used with a PWM signal. So, mCubed created an Attenuator that converts the PWM signal into an analog signal therefore allowing the T-Balancer to control fans quietly with an analog signal. This little gem has not had much attention from forums or review sites, so I am here today to share the information I’ve learned along with multiple configuration possibilities.
|All times are GMT +1. The time now is 19:39.|
Powered by vBulletin® - Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO