3 Waterblocks from All-in-One kits compared We use our own design heatsink test rig. The ambient temperature was regulated at 21 degrees Celsius. We run the heat source in our test rig at approximately 70, 115 & 170 Watts to show you how heatsinks perform under load. Use expensive top quality silicon based heatsink paste. The heatsink graph shows the temperature of a plate between the heat source and the heatsink. This is the temperature the heat source (processor) and heatsink are at their contact point in degrees Celsius on the left. http://www.a1-electronics.net/Heatsi...sts_Sept.shtml |
It must be ME .... always have a headache after reading their charts.:D |
no it's not you, I simply can't read them at all, the colors are too similar and the bars are too small, results is that I don't know which WB did what. :p |
All times are GMT +1. The time now is 04:02. |
Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO