Need dimensions for NB
 

Need the hole dimensions for a abit NF7 (rev2.0).

Its for a NB waterblok .

If you know dimensions for a X800pro post them also :)

I would say.. 6cm

heb je geen schuifmaat want zou de diameter van de gaatjes ook willen weten(ongeveer 3mm).

ziet er mij 6.1cm uit :p

dus afstand waar ik moet boren = 610 - 3 = 607mm

it looks like 6.1cm because the camera lense is pretty close up , thereby is makes it looks bigger.

I don't have a "schuifmaat" at my disposal, to get the most correct info, look into the abit forums.

most sure way is to remove the default NB cooler, and is it to measure and mark the holes you need in your home-made one :)

don't know if this is any help: http://www.overclockers.com/tips1110/

A man without a "schuifmaat" is a man without a penis :p

I'll try the abit forum :)


p.s : i could try 6cm , but need the dimensions of the holes also

no, a man without a "schuifmaat" is not worried about the size of his penis :p

Pfft , got examen so i don't have time to uninstall my whole setup.

But its a good idea , gonna uninstall it after my examens and just measure it with my mighty "schuifmaat" :)

or just use the mighty pen to draw 2 circles on the block :p

got my hs lying around here, pic with ruler