Mcw50-t problem I got the pelt setup running like this : pump -> dual bix rad -> cpu -> single bix rad -> mcw50-t and gf4ti4600 -> pump. But the gf4 is only at 22°c! (got the temps from the backside of the gpu) I've ran the pelt without the gf4 and it was doing -0°c in a few sec. First i got +-30°c but then i saw the mcw50-t wasn't making good contact. Now i've remounted it and its about 22°c.. My cpu @2425mhz is running at 35°c. I tought a pelt would run @ about +-5°c .. What am i doing wrong? |
where do you get 22°? if it's on the back, that's normal with such a card and with such a watercooling loop |
I got a a little temp probe and the sensor is at the back of the gpu.. Sure it's normal? Couse my cpu is only doing 10°c more without a pelt @ 2425 and 1.8vcore. All fans are on low speed and there's no fan on the single rad.. Still have to get one! So maybe that's the problem?;) |
All times are GMT +1. The time now is 12:54. |
Powered by vBulletin® - Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO