Originally posted by Da_BoKa
you should have taken a look at my res

http://www.overclocking.be/forum/showthread.php?t=8189

greetz

I'll have a look at the .pdf later. i had some plexi ready and chopped up to make a res, but I took a jam pot; If I wanted to change the tubing I can just switch the cap of the pot with a new one

I've thought well about everything I'm doing, don't think all I'm doing is messing around

euh, T, better make sure that the tube of the outlet goes deep enough in the jar, you need to suck the WATER from the res, not the AIR

Originally posted by ModdiN MansoN
euh, T, better make sure that the tube of the outlet goes deep enough in the jar, you need to suck the WATER from the res, not the AIR

the jam pot will be placed on it's side, so the pump tube will be at the bottom

ghetto

greetz

bought some noise isolating mats @ gamma, 11.39€/m²

all ready now to install my new mainboard

res

radiator, made a hole to put the connector through. I'm currently without dremel, so I just used my drill and a plier to make the hole. how ugly :/

mine is finished

@ teus don't forget to put some corrosion stuff, keep in mind you mixing 2 kinds of metal

Originally posted by vegeta
@ teus don't forget to put some corrosion stuff, keep in mind you mixing 2 kinds of metal

hmmm, forgot about that one. ah well, I'll just open up my reservoir and pour an additive in it.

what additive should I use, antifreeze? I don't think I can get waterwetter + it's bloody expensive