AZZA Fusion 3000 Full-Tower Chassis Review

@ 2012/02/16
On the outside our latest submission has a large and chunky presence. It starts with the large feet and is taken up the front and onto the top giving you a chassis reminiscent of something along the lines of the CM HAF cases, yet different enough to set this AZZA chassis apart if they were next to each other. On the inside things are taken to a whole new level in any gaming chassis I have seen. I have done a few server chassis reviews and even there I have not seen the amount of back planes for hard drive bays. I mean seriously, between the 2.5" and 3.5" bays, there are ten hot swap bays to play with here! On top of that, the only other thing inside the chassis I needed a tool for was the risers and motherboard screws. The rest is completely tool-less or uses thumbscrews.

This chassis I have been describing is the Fusion 3000 from AZZA. While I have hit on some interesting points already, those were just enough to peek your interest and are really just the tip of the iceberg as far as what this chassis offers both inside and out.

No comments available.