- Back to homepage

Danger Den NV-68 GFX Block Installation Guide

@ 2004/08/27

Once you have all the washers, springs and thumb screws in place you can now start to tighten the mounting bracket down by tightening two opposite corners (A & A) one full turn at a time followed by the same with the other opposite corners (B & B) until a firm and even pressure is applied and the block is secure...

back
Go To Full Article

No comments available.

All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.