Follow us on Twitter
Follow us on FacebookDon't lap a Direct Heatpipe Touch Heatsink
@ 2008/09/19
ow
ow
Comment
from jmke
@ 2008/09/19
ah found the source ! It happened in May this year
http://www.evga.com/forums/tm.asp?m=...&mpage=1&key=&
Quote:
| I lightly lapped my OCZ Vendetta 2 just to flatten a raised middle heatpipe which was about .5mm higher than the outer ones. So I went with 400, 600 and finally 800 grit sandpaper and I wanted to polish it. as I applied the polish and lightly pressed on the base, it caved in and cracked. |
Comment
from
@ 2008/09/19
0wned
Copyright © 2001-2011 Madshrimps, All rights reserved.
Graphic Design by Dennis Kestelle, Programming by Maarten Menten,
Overall Site design by John Meys
All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.
