Thermaltake DH-101 VF7001BNS

@ 2007/11/26
The chassis has a large bridging support between the back and the 5¼” Drive bays. This support runs across the CPU so your large passive coolers may have problems fitting, if so you can remove this bridge and have the chassis without it. Working forward from the rear, there is quick PCI release tools, very simple and easy to use, they hold quite well. But as always I suggest you remove them if you plan to install any expensive hardware in the slots, and screw the hardware in.

No comments available.

 

 

Copyright © 2001-2011 Madshrimps, All rights reserved.
Graphic Design by Dennis Kestelle, Programming by Maarten Menten, Overall Site design by John Meys

All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.

Madshrimps