MakerBot learns that 3D printing and copyright don't quite mix

@ 2016/02/28
Trying to stop unauthorized 3D printing is like plugging a hole in a dam with your finger -- once the template for an object leaks out, it's virtually impossible to stop the flood of bootleg prints. And MakerBot is learning this the hard way. The c...

No comments available.

 

 

Copyright © 2001-2011 Madshrimps, All rights reserved.
Graphic Design by Dennis Kestelle, Programming by Maarten Menten, Overall Site design by John Meys

All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.

Madshrimps