- Back to homepage

First 3D Printed Rifle Fired Successfully in Canada

@ 2013/07/29

A Canadian 3D tinkerer is the first to fire a 3D printed rifle 'successfully', but only if you have a low threshold of what constitutes successful. The printed rifle was fired 12 times before a bullet was put through the barrel and that shot split the receiver and barrel. Back to the drawing board, eh?

back
Go To Full Article

No comments available.

All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.