Fanless and silent

Completely fanless, virtually noiseless

Passive cooling through convective heat transfer

Perfect to be used in noise-sensitive environments

Fanless means less dust and thus virtually no maintenance required

 

Low power consumption

Power consumption: ca. 8.4 W (idle mode) and ca. 19.6 W (full load)

(Configuration: 4 GB RAM, 64 GB SSD and Windows 8.1)

 

Operation Position

Please make sure the system is always operated in

upright position using either its stand or the optional VESA mount.

Ventilation holes must not be blocked to ensure sufficient cooling.

 

Chassis

Dimensions without stand: 25.2 x 16.2 x 3.85 cm (DxHxW) = 1.57 L

Hole for Kensington Lock at the back panel

Optional accessory: 75mm and 100mm VESA mounting kit (PV01)

 

Operation System

This system comes without operating system.

It is compatible with Windows 7 / 8.1 / 10 (64-bit) und Linux (64-bit)

Caution: Windows 8 is not supported

 

Processor

Intel Celeron N3050, Dual Core

CPU clock frequency: 1.6 GHz, max. Turbo frequency: 2.16 GHz

Braswell platform, Airmont architecture, 14 nm structure

CPU cores / Threads: 2 / 2

Cache: 2 MB

Thermal Design Power (TDP): 6 W

Scenario Design Power (SDP): 4 W

Supports AES-NI and VT-x

SOC design with integrated graphics processor, no chipset required

 

Integrated Graphics

The Graphics Processing Unit (GPU) is integrated into the processor

Intel HD Graphics (8th Gen), graphics frequency: 320~600 MHz

Supports DirectX 11.2, OpenGL, Quick Sync

Execution Units (EU): 12

Three video outputs:

- HDMI 1.4b: max. 1920 x 1200 resolution @ 60Hz

- Display Port 1.1a: max. 2560 x 1600 resolution @ 60Hz

- D-Sub (VGA): max. 1920 x 1200 resolution @ 60Hz

Triple display: supports max. three independent displays simultaneously

 

UEFI Firmware

8Mbit Flash ROM with AMI's Aptio UEFI BIOS Firmware

Based on the Unified Extensible Firmware Interface (UEFI)

Supports Power fail resume / AC power on state / always on / always off

Supports Wake-on-LAN (WOL) from S3, S3, S5 ACPI states

Supports boot up from external flash memory cards

 

Memory

1x SO-DIMM slot with 204 pins

Supports one module DDR3L-1333 (PC3-10600) at 1.35V

Maximum capacity: 8 GB

DDR3L-1600 is supported at DDR3L-1333 clock rate

Caution: This mainboard does only support 1.35V DDR3L memory modules.

DDR3L has a lower operation voltage compared to DDR3

 

Optical Drive (optional)

Supports one optical DVD or Blu-ray slim-line drive

Serial ATA interface, 12.7 mm height, slimline SATA connector

 

Hard disk drive/SSD (2.5")

Supports one Serial ATA hard disk (5400 / 7200 rpm)

or one SATA SSD drive in 6.35cm/2.5" format

Serial ATA III Interface with up to 600 MB/s transfer speed

Supports a drive with a max. height of 9.5 mm

Supports Unified Extensible Firmware Interface (UEFI)

 

Integrated Audio

Realtek ALC269 Audio Codec with Azalia and D3 mode support

Two analog audio connectors (3.5mm):

1) Line out (head phone)

2) Microphone input

 

Card Reader

Integrated card reader

supports standard SD, SDHC and SDXC memory flash cards

 

Wired Network

RJ45 connector supports Gigabit LAN at 10/100/1000 Mbit/sec.

Intel i211 Ethernet Controller with MAC, PHY and PCIe interface

Supports Wake-on-LAN

 

Wireless Network (WLAN)

Half-size Mini PCIe WLAN card

WLAN chip: Realtek RTL8188EE

Supports IEEE 802.11b/g/n, max. 150Mbps up-/downstream (1T1R)

 

LEDs and Buttons

Power button

Power LED (blue)

 

Front Panel Connectors

1x USB 2.0

SD card reader

 

Back Panel Connectors

HDMI 1.4b digital video and audio output

DisplayPort 1.1a digital video and audio output

D-Sub/ VGA analog video output (15-pin)

2x USB 3.0

2x USB 2.0

Gigabit network (LAN, RJ45)

Audio Line-out (head phones)

Microphone input

DC input for the external power adapter

Perforation for TV antenna (diameter: 9 mm)

 

Internal USB Connectors

Internal USB 2.0 Type-A connector for USB dongle

(for e.g. memory stick, 3G stick, DVB-T stick, etc.)

Boot function supported.

 

Power Supply

External 40W AC/DC power adapter (fanless)

AC Input: 100~240V AC, 50~60 Hz

DC Output: 19V / 2.1 A

Automatic voltage adjust

Dimensions: 89.5 x 37 x 26.5 mm (LWH)

DC Connector: 5.5/2.5mm (outer/inner diameter)

 

Optional Accessories

1) VESA mount made of metal (PV01)

2) Adapter for second 2.5" drive instead of optical drive (PHD2N)

 

24/7 Nonstop Operation

This device is approved for 24/7 permanent operation.

Requirements:

- Free air circulation around the PC must be guaranteed.

- Ventilation holes must be kept clear.

- Any installed hard disk must also be approved for permanent

operation by its manufacturer (max. one hard disk)

 

Environmental Spec

Operating temperature range: 0~35°C

Relative humidity range: 10~90% (non-condensing)

 

Certification and Compliance

EMI: CE, FCC, BSMI, C-Tick

Safety: CB, BSMI, ETL

Other compliances: RoHS, Eup Lot6

This device is classed as a technical information

equipment (ITE) in class B and is intended for use in

living room and office. The CE-mark approves the

conformity by the EU-guidelines:

- EMV-guideline 89/336/EWG electromagnetic tolerance

- LVD-guideline 73/23/EWG use of electric devices within certain voltage-limits