Avexir comes to help system builders or enthusiasts which would like to pair the components inside the computer esthetically in order to have a cleaner and more professional look. The Blitz 1.1 modules are also equipped with LEDs for offering additional eye candy and the heatspreaders are quite easy to disassemble.
JEDEC standard 1.5V± 0.075V PowerSupply
VDDQ = 1.5V ± 0.075V
800MHz fCK for 1600Mb/sec/pin
8 independent internal bank
Programmable CAS Latency: 7,8,9,10,11
Posted CAS
Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
Programmable CAS Write Latency(CWL) = 8 (DDR3-1600K)
8-bit pre-fetch
Burst Length: 8 (Interleave)without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly usingA12 or MRS]
Bi-directional Differential Data Strobe
Internal(self) calibration : Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)
On Die Termination using ODT pin
Average Refresh Period 7.8us at lower than TCASE 85?, 3.9us at 85? < TCASE ≤ 95?
Asynchronous Reset
PCB: Height 1.180"(30.00mm), double sided component
Copyright © 2001-2011 Madshrimps, All rights reserved.
Graphic Design by Dennis Kestelle, Programming by Maarten Menten,
Overall Site design by John Meys
All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.
Follow us on Twitter
Follow us on Facebook