The phone can be installed inside the case by simply sliding it from top to bottom:

Again, let’s look how the phone looks like inside the Brando Workshop case:

Bottom

Right Side

Top Side

Left Side

Both bottom and top covers of the case are noticeably thicker than the Noreve Tradition, but what we did not like in particular was the fact that the holding clips on the sides are a little bit too rigid, at least on the first use and they seem to lift up the screen protector in the same area.

The belt clip mechanism is made from two main components, one which must be installed to the back of the case:

The circular component must be properly secured, in order not to have unpleasant incidents like the phone falling off:

The assembly can be mounted to the plastic belt clip in a couple of seconds; a “click” sound should be heard and the case will be secured:

In order to remove the case from the belt clip, we will have to press on the top black plastic button: