Motherboards/IntegratedCPU by stefan @ 2013-02-05
The NM70-I2 motherboard from ECS comes equipped with either the Intel Celeron 847 1.1GHz dual-core or the Intel Celeron 807 1.5GHz single core CPU, has Intel HD Graphics for video output, supports installation of two DDR3 memory modules and also comes with 4 SATA ports, one of them supporting the 6Gbps standard.
The PWM of the board is controlled by the Richtek RT8167A dual single-phase synchronous Buck:
The parallel port header and the CMOS jumper can be found on the top side of the board:
Nearby we will also find a free system fan header:
The bottom side of the board comes with the NM70 PCH, along with four SATA ports (3xSATA2 and a single SATA3) and the PCI-Express slot; between the memory slots and the PCI-Express slot we will also get two Front Panel USB 2.0 headers, the SPDIF out and Case open headers:
Near the UEFI chip we will also find the Front Panel header:
The ATX 24-pin power connector is situated near the two grey memory slots:
Between the CPU and the memory slots we will find the CMOS battery, along with a small buzzer:
The CPU is covered with a small heatsink, which is also cooled by a small fan, which is silent at all times:
On the I/O, we will find A PS/2 mouse and keyboard port, one VGA port, HDMI, a COM port, 4 USB 2.0 ports, the LAN port and the audio jacks:
Copyright © 2001-2011 Madshrimps, All rights reserved.
Graphic Design by Dennis Kestelle, Programming by Maarten Menten,
Overall Site design by John Meys
All information and graphics contained in Madshrimps are sole property of the Madshrimps crew and may not be reproduced or copied in any manner without written permission from us.
Follow us on Twitter
Follow us on Facebook