On the back of the fans, we can locate the Antec logo:
Both fans that come with the 920 are PWM (four wires); the fan supplied with the 620 model had only two wires:
For additional protection, the pump/block is wrapped inside a small plastic bag:
The top side of the pump/block combo looks similar to the one on the 620 model, but now under the Antec logo we can find a multicolored LED, fully customizable via the supplied application:
The thermal compound comes pre-applied; a plastic cap is used for protection and has to be removed prior to installation, by rotating and lifting it up:
After the installation has been completed, the two PWM fans need to be connected to the respective headers:
The 3-pin connector must be plugged in the CPU Fan header on the motherboard (the software regulation must be disabled on this header from the BIOS/UEFI):
The USB cable is used for being able to communicate with the pump (via the supplied software utility):
While looking at the radiator, we can find the holes needed to mount both fans with the supplied screws; it has a higher depth compared to the 620 radiator (49mm vs 27mm):
The top side holds the product serial number: