Budget _Shark_ Cutout Howto

Howto by FrenzY @ 2003-09-03

Don't want to spend a fortune on tools and still end up with a great looking cut-out? Then check out this fine piece of work by FrenzY!
  • prev
  • next

DAY 2

DAY 2:

After 1 hour and half I ended up with quite a nice result, thanks to the very fine blades of the saw I was able to do a lot of fine detail work without much hassle.

Madshrimps (c)


Then I started working on the different parts needed for the Shark-Tribal and glued the design examples to the removed aluminum center piece of the side-panel

Madshrimps (c)


Some time later I ended up with the following

Madshrimps (c)


And when put on the plexi panel it looks like this

Madshrimps (c)



Onto the final stage!
  • prev
  • next
Comment from Bosw8er @ 2003/09/03
Good stuff !

Only 6,4 EUR
Comment from the maniak @ 2003/09/04
good and simple and cheap


btw nice logo
Comment from FrenzY @ 2003/09/04
thx
Comment from jmke @ 2003/09/04
FrenzY where did you find the Tribal Shark Etching? Got any links?
Comment from FrenzY @ 2003/09/04
I used the force
Comment from TeuS @ 2003/09/04
I prefer hoehel
Comment from Unregistered @ 2003/09/06
very nicely done!
Comment from Da_BoKa @ 2003/09/10
nice piece of art

and for the guy's from antwerp try www. goegel.be


btw teus from where are you?? i'm from torhout ( very close to roeselare )

greetz
Comment from TeuS @ 2003/09/10
@offtopic spammor:

Location: Ieper
If you don't know that city is 15 miles away from your town, you're not worth living
Comment from jmke @ 2003/09/24
Comment from Bosw8er @ 2003/09/24
Quote:
Originally posted by jmke
http://rotter.net/nor/hard/5318.shtml
îôñ÷ ÷èï ùñîúé òì äôìñèé÷ ?
Comment from jmke @ 2003/09/24
äòøä ÷èðä- îåîìõ áçåÃ* ìùééó äéèá Ã*ú äîñáéá éøÃ*ä äøáä éåúø Ã*ñúèé åðçîã !!
Comment from Da_BoKa @ 2003/09/24
.
Comment from Unregistered @ 2004/05/30
Wie heeft er diene haai int groot?
Comment from kristos @ 2004/05/31
just copy it and enlarge it to the dimensions you like

 

reply